(Page 11 of 81 in this chapter) Version

Clocking.HBus.ClockMode

For information about setting up CT bus clocking, and rules and restrictions for configuring CT bus clocking, refer to Section 3.5, Configuring Board Clocking.

Value	Description
`MASTER_A`	The board is used to drive the CT bus A clock based on the timing information derived from a clocking source.
`MASTER_B`	The board is used to drive the CT bus B clock based on the timing information derived from a clocking source.
`SLAVE`	The board acts as a clock slave, deriving its timing from the primary bus master. Note: Connections are allowed to the board's CT bus timeslots.
`STANDALONE`	The board references its timing signal from its own oscillator or a digital network source, and does not drive any CT bus timing signal clocks. Note: Connections are not allowed to the board's CT bus timeslots in standalone mode.