(Page 16 of 82 in this chapter)
Version
Clocking.HBus.NetRef2Source
For information about setting up CT bus clocking, and rules and restrictions for configuring CT bus clocking, refer to
Section 3.5,
Configuring Board Clocking
.
Syntax
Clocking.HBus.NetRef2Source =
source
Access
Read/Write
Type
String
Default
STANDALONE
Allowed Values
STANDALONE
Example
Clocking.HBus.NetRef2Source = STANDALONE
Description
Specifies the source to drive the
NETREF2
timing signal on the CT bus.
Value
Description
STANDALONE
The
NETREF2
timing signal is not driven.
(Page 16 of 82 in this chapter)
Version
Want to send us feedback on our documentation? Email:
Tech_Pubs@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights reserved.
(Page 16 of 82 in this chapter) Version (Page 16 of 82 in this chapter) Version