(Page 9 of 80 in this chapter) Version

Clocking.HBus.ClockMode

For information about setting up CT bus clocking, and rules and restrictions for configuring CT bus clocking, refer to Section 3.5, Configuring Board Clocking.

Value	Description
`MASTER_A`	The board is used to drive the CT bus A clock based on the timing information derived from a clocking source.
`MASTER_B`	The board is used to drive the CT bus B clock based on the timing information derived from a clocking source.
`SLAVE`	The board acts as a clock slave, deriving its timing from the primary bus master. Note: Connections are allowed to the board's CT bus timeslots.
`STANDALONE`	The board references its timing signal from its own oscillator or a digital network source, and does not drive any CT bus timing signal clocks. Note: Connections are not allowed to the board's CT bus timeslots in standalone mode.