(Page 11 of 80 in this chapter)
Version
Clocking.HBus.ClockSourceNetwork
For information about setting up CT bus clocking, and rules and restrictions for configuring CT bus clocking, refer to
Section 3.5,
Configuring Board Clocking
.
Syntax
Clocking.HBus.ClockSourceNetwork =
network_number
Access
Read/Write
Type
Integer
Default
1
Allowed Values
1 | 2 | 3 | 4
Example
Clocking.HBus.ClockSourceNetwork = 1
Description
Specifies the number of a trunk that the board uses as an external network timing reference for its internal clock.
If the
Clocking.HBus.ClockSource
keyword is not set to
NETWORK
, this keyword is ignored.
Caution:
The
Clocking.HBus.ClockSourceNetwork
entry is a one based number, while the
x
entry in the
NetworkInterface.T1E1[x].Type
keyword is a zero based
number.
See Also
Clocking.HBus.ClockSource
(Page 11 of 80 in this chapter)
Version
Want to send us feedback on our documentation? Email:
Tech_Pubs@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights reserved.
(Page 11 of 80 in this chapter) Version (Page 11 of 80 in this chapter) Version