(Page 60 of 80 in this chapter) Version
NetworkInterface.T1E1[x].ISDN.NFAS_ MEMBER[y].NAI
Syntax
- NetworkInterface.T1E1[x].ISDN.NFAS_MEMBER[y].NAI = setting
- x = 0 | 1 | 2 | 3
- y = NFAS group member index
Access
- Read/Write
Type
- Integer
Default
- For every member of an NFAS group, this keyword must be set in the configuration file of the board where the D Channel resides.
Allowed Values
- 0 - 127
Example
- NetworkInterface.T1E1[0].ISDN.NFAS_MEMBER[1].NAI = 4
Description
- The Network Access Identifier (NAI) for this NFAS member. An ISDN application uses this number to refer to the trunk within an NFAS group. The NAI of each trunk in an NFAS group must be unique.
- This keyword is valid only on the trunk where NetworkInterface.T1E1[x].D_Channel = ISDN.
- If an NFAS group is not defined, there will only be one trunk controlled by every D Channel (the trunk where the D Channel resides). In that case, the ISDN stack will set the NAI to be equal to the trunk number. If you want the NAI for an interface to be different from the trunk number, define an NFAS group consisting of one trunk and explicitly set the NAI.
- For more information about NFAS groups, refer to the NMS ISDN Installation Manual.
Note: If there is not a NetworkInterface.T1E1[x].SignalingType keyword in the ISDN configurations, an ISDN_BAD_NAI error may be returned - even if the NetworkInterface.T1E1[x].ISDN.NFAS_MEMBER[y].NAI keyword is correct. NetworkInterface.T1E1[x].SignalingType defaults to CAS.
See Also
- NetworkInterface.T1E1[x].SignalingType, NetworkInterface.T1E1[x].D_Channel, NetworkInterface.T1E1[x].ISDN.D_Channel_Backup_Trunk, NetworkInterface.T1E1[x].ISDN.NFAS_ MEMBER[y].Board, NetworkInterface.T1E1[x].ISDN.NFAS_ MEMBER[y].Trunk, NetworkInterface.T1E1[x].ISDN.NFASGroup
(Page 60 of 80 in this chapter) Version
Want to send us feedback on our documentation? Email: Tech_Pubs@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights
reserved.