(Page 8 of 40 in this chapter)
Version
Clocking.HBus.ClockMode
Syntax
Clocking.HBus.ClockMode =
clockmode
Access
Read/Write
Type
String
Default
MASTER_A
Allowed Values
MASTER_A
|
SLAVE
Example
Clocking.HBus.ClockMode = MASTER_A
Description
This keyword is valid for QX 2000/100-4L boards only. It specifies the board's control of the H.100 clock.
Valid entries for this keyword include:
Value
Description
MASTER_A
The board will serve as clock master, driving the CT bus A clock based on the clocking information derived from the timing references specified with
Clocking.HBus.ClockSource
SLAVE
The board will act as a clock slave, deriving its timing from the primary clock master.
Note: Connections are allowed to the board's CT bus timeslots.
For more information about QX board clocking, refer to
Chapter 5
. For general information about CT bus clocking, refer to the
OAM System User's Manual
.
See Also
Clocking.HBus.AutoFallBack
,
Clocking.HBus.ClockSource
,
Clocking.HBus.FallBackClockSource
(Page 8 of 40 in this chapter)
Version
Want to send us feedback on our documentation? Email:
Tech_Pubs@nmss.com
Copyright © 2000, Natural MicroSystems, Inc. All rights reserved.
(Page 8 of 40 in this chapter) Version (Page 8 of 40 in this chapter) Version