Table of Contents Index NMS Glossary Previous Page Next Page Version

Chapter 6

Demonstration Program

6.1 intapi

6.1 intapiTop of Page

NMS TAPI includes the intapi demonstration program for verifying installation and demonstrating the software's capabilities. The following section describes how to use the program.

Name

intapi

Description

Demonstrates the following TAPI-based inbound call-control functionality:

Requirements

intapi requires the following hardware and software:

Usage

intapi [options]

where options are:
Option

 Description

-l[line_number]

 Specifies the line number of the TAPI line to use. Default = 0.

-?

 Displays instructions for using intapi.

Procedure

 Note: Before running intapi, make sure that NMS TAPI is configured appropriately for your NMS board, and that a handset is connected to the board directly, or through a CO simulator or PBX.
To run intapi:

  1. Open a command window and navigate to the directory where intapi.exe resides (typically in \nms\nmstapi\demos\intapi).

    

  2. Enter the following command on the command line:
    

    
intapi -l[line_number]
    
where [line_number] is the TAPI line number (for example, intapi  -l0).
    

  3. Press Enter. The application reaches a Connected state. The demo is initialized and produces a "Ready to receive calls" message.
    

    

  4. Pick up the phone and dial into the phone on the TAPI line you specified. The following phone message will play: "Thank you for calling. Press 1 to record, 2 to play, and 3 to hang up." 
    

    

  5. Press 1 to record a message.
    

    

  6. Press 2 to play the recorded message.
    

    

  7. Press 3 to disconnect the call.
    

    

  8. Hang up the phone to disconnect.
    









 
Table of Contents Index NMS Glossary Previous Page Next Page Version




 




Want to send us feedback on our documentation?  Email: Tech_Pubs@nmss.com



Copyright © 2001, Natural MicroSystems, Inc.   All rights
reserved.