- The utility program mc1tst confirms the MC1 board has been properly installed and performs configuration and stream diagnostics. Under UNIX, the utility can be found in /opt/nms/bin. Under Windows NT and OS/2, the utility can be found in \nms\bin. If you have not already done so, add the directory to your path.
Note: It is important that no other card in the chassis is driving any of the MVIP streams. It is also required that no other MC1 Interface Cards are driving any MC1 streams. This can be assured by removing both the MVIP interconnect cable and the MC1 interconnect cable from the board being tested.
- Execute the mc1tst program by entering:
mc1tst
- mc1tst tests four streams at a time during which the status of the MC1 configuration will be displayed. At the end of the test the following message should appear:
The MC1 Interface Card checks out.
- If any errors occur, check the following:
(Page 3 of 4 in this chapter)