Previous PageTable Of ContentsIndexNext Page



Appendix D: Timer Values

Introduction

This appendix lists the values assigned to various ISDN timers for different country variants. These timers control the behavior of network signaling layer 3 in the ISDN protocol stack.

These values are included as timer_val_t structures in the ISDN_ PROTOCOL_PARMS_Q931CC and ISDN_PROTOCOL_PARMS_LAPD structures referenced by isdnStartProtocol.

Timer Functions

The following table summarizes the meanings of the timers. The items shown in all Capital letters are the names of Q.931 messages. For example, ALERT refers to the alert message indicating that an incoming call has arrived.

Timer Values

The following tables indicate the values of the timers for each of the supported operators.

France VN6 Layer 3 Timer Defaults

timer_val_t vn6[VN6_T_LAST]

EuroISDN Layer 3 Timer Defaults

timer_val_t ets[ETS_T_LAST]

AT&T E9 and E10 Layer 3 Timer Defaults

timer_val_t e9[E9_T_LAST]

timer_val_t e10[E10_T_LAST]

Nortel DMS 100 Layer 3 Timer Defaults

timer_val_t dms[DMS_T_LAST]

USA National ISDN-2 Layer 3 Timer Defaults

timer_val_t ni2[NI2_T_LAST]

Australian Telecom 1 Layer 3 Timer Defaults

timer_val_t au1[AU1_T_LAST]

Hong Kong Telephone Layer 3 Timer Defaults

timer_val_t hkt[HKT_T_LAST]

INS-1500 NTT Layer 3 Timer Defaults

timer_val_t ntt[NTT_T_LAST]


Natural MicroSystems, Inc.
100 Crossing Boulevard
Framingham, MA 01702

Contact Developer Support

Previous PageTable Of ContentsIndexNext Page