(Page 3 of 5 in this chapter)
2.2 System Requirements
- Since the AG Connect board is used with additional MVIP-compatible boards, the exact system requirements depend on all the cards in the system. A typical PC should have:
- At least 6 MB of memory (excluding operating system requirements).
- At least 25 MHz 386DX, 486, or Pentium microprocessor.
- One of the following operating systems installed: OS/2TM, Windows NTTM
3.51, UnixWare® 2.1, or SCO® OpenServerTM 5.
- An uninterruptable power supply (UPS). Although a UPS is not strictly
required, it is strongly recommended for increased system reliability. Note
that the UPS need not power the PC's video monitor.
- An MVIP connector cable to connect your boards together on the MVIP
bus. The cable length and number of connectors on the cable should not
greatly exceed the number of boards in your system.
- (S Connect-x and S/T Connect products only) An external power supply.
For details, see section 2.4.3.
- An adapter cable to connect your AG Connect board to your telephone lines.
For details, see section 2.4.2.
(Page 3 of 5 in this chapter)
Tech_Support@nmss.com
Copyright © 1996, Natural MicroSystems, Inc. All rights
reserved.