(Page 2 of 4 in this chapter)

6.1 Introduction

Supplied with the AG Connect driver software are several demonstration scripts. You can use these scripts with the demonstration programs shipped with SwitchPath or AG Access to make the programs operate with the AG Connect board. This chapter describes the scripts and programs, and explains how to run them.
Scripts are provided for use with the following demonstration programs: Program Description Shipped With: ati2mvip Demonstrates switching voice data on an analog loop start line interface to the MVIP bus. Requires an AG-8 board and ME/2/X. SwitchPath dial2asi Demonstrates automatic call delivery. Requires an AG resource board and ME/2/X. SwitchPath inadi Demonstrates inbound call-control functions. Requires an AG resource board and AG Access. AG Access outadi Demonstrates outbound call-control functions. Requires an AG resource board and AG Access. AG Access aditest Exercises operator workstation interfaces using AG Access. AG Access

Program	Description	Shipped With:
`ati2mvip`	Demonstrates switching voice data on an analog loop start line interface to the MVIP bus. Requires an AG-8 board and ME/2/X.	SwitchPath
`dial2asi`	Demonstrates automatic call delivery. Requires an AG resource board and ME/2/X.	SwitchPath
`inadi`	Demonstrates inbound call-control functions. Requires an AG resource board and AG Access.	AG Access
`outadi`	Demonstrates outbound call-control functions. Requires an AG resource board and AG Access.	AG Access
`aditest`	Exercises operator workstation interfaces using AG Access.	AG Access

(Page 2 of 4 in this chapter)