(Page 1 of 12 in this chapter)

Chapter 6

ADI Service: Call Control

6.1 Introduction
6.1.1 Call Control and Protocol
Independence
6.2 Telephone Network Events
6.2.1 Informational Events
6.2.2 Transitional Events
6.3 Responding to Inbound Calls
6.3.1 Inbound Call Parameters
6.3.2 Inbound Call Events
6.3.3 Performing Caller ID on
Inbound Calls
6.4 Establishing Outbound Calls
6.4.1 Call Control Mask
Parameters
6.4.2 Connectmask
6.4.3 Disconnectmask
6.4.4 Using Telephone Network Tone Detection
6.4.5 Using Precise Tone Detection
6.4.6 Using Broadband Tone
Detection
6.4.7 Using Voice Detection
6.4.8 Using Call Placement
Timeout
6.4.9 Outbound Call Parameters
6.4.10 Outbound Call Events
6.5 Releasing Calls
6.5.1 Telephone Network-
Initiated Release
6.5.2 Application-Initiated
Release
6.5.3 Call Release Parameters
6.5.4 Call Release Events
6.6 Blocking and Unblocking Calls
6.6.1 Call Blocking Parameters
6.6.2 Call Blocking Events
6.7 Managing Service Interruption
6.8 Transferring Calls
6.8.1 Using Supervised Transfer
6.8.2 Using Blind Transfer
6.8.3 Call Transfer Parameters
6.8.4 Call Transfer Events
6.9 State Diagrams
6.10 Protocol Specific Parameters
6.10.1 Loop-Start Parameters
6.10.2 Wink-Start and DID
Parameters
6.11 System Restrictions

(Page 1 of 12 in this chapter)

Tech_Support@nmss.com
Copyright © 1996, Natural MicroSystems, Inc. All rights reserved.