(Page 3 of 5 in this chapter)

1.2 AG Board Software Installation and Configuration

Installing AG Access loads the software components (shown in Figure 3) necessary to develop applications. The AG Access/ADI service function library contains the adi functions used in the application for voice and call processing. The AG board driver interfaces to the AG board. The agmon utility initializes the AG board based on the configuration you specify in the AG configuration file (ag.cfg).
Figure 3. AG Board Installation & Configuration
Before developing an application using AG Access, complete the following installation steps: Installation Step: For details, see... Install AG Access software Chapter 2 If using CT Access, install CT Access The CT Access Installation Manual Edit AG configuration file Chapter 4 Run agmon to configure AG board Chapter 5 Verify your installation Chapter 3 of this manual (for AG Access) or the CT Access Installation Manual (for CT Access)

Installation Step:	For details, see...
Install AG Access software	Chapter 2
If using CT Access, install CT Access	The CT Access Installation Manual
Edit AG configuration file	Chapter 4
Run `agmon` to configure AG board	Chapter 5
Verify your installation	Chapter 3 of this manual (for AG Access) or the CT Access Installation Manual (for CT Access)

(Page 3 of 5 in this chapter)