(Page 2 of 8 in this chapter)
1.1 Introduction
- NaturalText is a C function library component of CT Access that provides speech recognition functionality. It runs on the following NMS board sets:
· AG-T1 with Diva II
· AG-E1 (75 ohm) with Diva II
· AG-E1 (120 ohm) with Diva II
· AG-24+ with Diva II
· AG-30 with Diva II
- This chapter lists procedures for installing the NaturalText software under:
- OS/2 3.0 or later
- UnixWare 2.1 or later
- Before you begin, make sure you have already installed:
- CT Access, as described in the CT Access Installation Manual
- You will be performing the following steps to install NaturalText on your system:
- modifying your AG configuration files to include the NaturalText software;
- activating your NaturalText licenses.
(Page 2 of 8 in this chapter)
tech_support@nmss.com
Copyright © 1997, Natural MicroSystems, Inc. All rights
reserved.