Fusion Installation Manual

P/N 6380-11

(Page 1 of 1 in this chapter)

Table of Contents

Organization


About This Manual

Document Conventions
Related Documents


Developer Support

1 Fusion Configurations

1.1 Fusion System Requirements
1.2 Fusion Configurations
1.2.1 Fusion GSM T1 Span
1.2.2 Fusion GSM E1 Span
1.2.3 Fusion GSM Analog
1.3 TX2000 Configurations
1.3.1 TX2000 Software Libraries
1.3.2 TX2000 Hardware Configurations

2 Installing Fusion Software

2.1 Introduction
2.1.1 Installing over Previously Installed Fusion Software
2.2 Installing TX2000 Software
2.2.1 Installing the TX2000 Base/Device Driver for Windows NT
2.2.2 Installing TX Series Fusion Developers Kit Software
2.2.3 Installing TX Series Ethernet/NIC Drivers
2.2.4 Installing New Release TX Software over Existing Software
2.2.5 Adding a New TX2000 Board to an Existing Installation
2.3 Installing AG RealTime GSM-HDLC TRAU Software

3 Verifying the Installation

3.1 Introduction
3.2 Setting Up Fusion Test Configurations
3.3 Using the TRAU Exerciser Program
3.3.1 Running the TRAU Exerciser
3.4 Verifying the TX2000 Installation
3.5 Verifying Fusion Network Connections
3.6 Running Fusion Demonstration Programs
3.7 Troubleshooting Fusion Configurations with cpcon

4 Software Removal

4.1 Removing Fusion TX2000 Software
4.2 Removing AG-RT GSM-HDLC TRAU Software

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 1997, Natural MicroSystems, Inc. All rights reserved.