This manual describes how to install Natural MicroSystems AG ISDN software on your system. This software allows an Alliance Generation board to connect with a T1 or E1 trunk using Primary Rate ISDN.
This document is targeted to developers of telephony and voice applications who are using CT Access or AG Access. This document defines telephony terms where applicable, but assumes that the reader is familiar with telephony concepts. It also assumes that the user is familiar with C programming.
The manual is organized as follows:
|
For... |
See... |
|
An overview of the components of the AG ISDN software package, and a list and description of additional components you will need |
Chapter 1: Introduction |
|
Instructions for installing AG ISDN software packages under various operating systems |
|
|
Instructions for editing your AG configuration file so it corresponds to your setup |
Chapter 3: Editing Your AG Configuration File |
|
Procedures for removing AG ISDN software from your system |
Chapter 4: Software Removal |
For more information about related NMS products, refer to these manuals:
General
|
This manual... |
Provides... |
|
Getting Started With MVIP Switching |
A history of digital switching, details on MVIP switching. |
|
AG ISDN for Natural Call Control Developer's Manual |
Information on building applications that interface with the AG ISDN protocol stack at the NMS CT Access or AG Access API level. |
|
AG ISDN Messaging API Developer's Reference Manual |
Information on building applications that interface with the ISDN protocol stack via the AG ISDN Messaging API. |
Hardware
|
This manual... |
Provides... |
|
AG-T1 and AG-E1 Installation and Developer's Manual |
Installation procedures for an AG-T1 or AG-E1 board, and instructions for configuring it for use. Also introduces T1 and E1 transmissions and signaling. |
|
AG Quad Installation and Developer's Manual |
Instructions for installing an AG Quad board, and how to configure it for use. Also introduces T1 and E1 transmissions and signaling. |
CT Access
|
This manual... |
Provides... |
|
CT Access Developer's Reference Manual |
An overview of CT Access and a reference of functions, events, reason codes, and errors. |
|
CT Access Installation Manual |
A description of the installation of the software from the distribution diskettes and the configuration file. It also provides a procedure for verifying your installation. |
|
AG Access Installation Manual |
The installation procedure for the ADI service component of CT Access (AG Access). |
|
AG Runtime Configuration and Developer's Manual |
Information about the AG configuration file, agmon, AG board and driver error messages, and AG task processors. |
The following manuals provide an overview of the capabilities and functions of the AG ISDN-compatible services that use CT Access:
AG Access
|
This manual... |
Provides... |
|
AG Access Developer's Manual |
Descriptions of how to use the AG Access API. |
|
AG Access Function Reference Manual |
A comprehensive reference of functions, events, reason codes, and errors. |
|
SW Utility User's Guide |
An overview of SW Utility operation and commands. |
|
SwitchPath Technical Reference Manual |
An overview of SwitchPath operation and commands. |
Bus Standards
|
This manual... |
Provides... |
|
ECTF: H.100 Revision 1.0 Hardware Compatibility Specification: CT Bus |
Information about the H.100 telephony bus, available from ECTF. |
|
MVIP-95 Device Driver Standard |
Information about MVIP-95, available from GO-MVIP. |
|
MVIP-90 Standard |
Information about MVIP-90, available from GO-MVIP. |
|
For GO-MVIP information, contact: GO-MVIP, Inc. |
For ECTF information, contact: ECTF |
Natural MicroSystems, Inc.
100 Crossing Boulevard
Framingham, MA 01702