(Page 1 of 1 in this chapter)

Chapter 4

Verifying the Installation

4.1 Introduction
4.2 Verifying the Installation

4.1 Introduction

Once you have installed your AG ISDN software, verify that the software is operational before you continue.

When running the AG ISDN verification procedure, it is assumed that:

4.2 Verifying the Installation

To verify your installation, run the isdndemo demonstration program supplied with your AG ISDN software.

To run isdndemo:

  1. Create an AG configuration file specific to your installation, as described in Chapter 3.

  2. Invoke agmon to initialize your AG boards.

    To run agmon on Windows NT, open a command window and enter:

    agmon

    To run agmon on UNIX:

    1. Log in as root (or become the super-user). 

      

    2. On a graphical user interface, start a terminal session (shell prompt). 
      

      

    3. Enter: agmon 
      

      
Note:  agmon should be left running at all times so errors will be captured. 

    


  3. Change to the directory containing isdndemo:
    

-	 Windows NT:   \nms\ctaccess\demos\isdndemo\
    

-	 UNIX:  opt/nms/ctaccess/demos/isdndemo/
    


  4. Run isdndemo.  To do so, enter:
    

isdndemo -p nn
    

...where nn is the protocol variant to run. Use 23 for USA (AT&T 5ESS10), 11 for Europe (EuroISDN), 9 for Asia (INS-1500 NTT), or 16 for QSIG.
    

isdndemo should respond with a message like the following:
    

       ISDN Multiple Thread Demo V.8 (Apr 13 1998)
   T1 board 0 found.
   Protocol = AT&T 5E10
   Number of inbound  ports = 23
   Number of outbound ports = 0
   24 ports opened.
   NOCC protocol started on 23 ports.
   Started 23 threads...
   Enter program test loop...









 
    (Page 1 of 1 in this chapter)




 




tech_support@nmss.com



Copyright © 1999, Natural MicroSystems, Inc.   All rights
reserved.