(Page 1 of 1 in this chapter)

About This Manual

The AG ISDN Installation Manual describes how to install Natural MicroSystems AG ISDN software on your system. This software enables an Alliance Generation board to connect to a T1 or E1 trunk using Primary Rate ISDN.

This document is targeted to developers of telephony and voice applications who are using CT Access. This manual defines telephony terms where applicable, but assumes that the reader is familiar with telephony concepts. It also assumes that the user is familiar with the C programming language.

The manual is organized as follows:
For...

 See...

An overview of the AG ISDN software components, and a list and description of additional components you will need

 Chapter 1 - Introduction

Instructions for installing AG ISDN under various operating systems

 Chapter 2 -Installing the Software

Instructions for editing your AG configuration file so it corresponds to your setup

 Chapter 3 - Editing Your AG Configuration File

Procedures for verifying your installation

 Chapter 4 - Verifying the Installation

Procedures for removing AG ISDN from your system

 Chapter 5 - Removing the Software

A list of network protocol variants and associated specifications

 Appendix A - Variant Specifications

Related Documents

For more information about NMS products, refer to these manuals:

General
This manual...

 Provides...

Getting Started With MVIP Switching

 An overview of digital switching, details on MVIP switching.

AG ISDN for Natural Call Control Developer's Manual

 Information on building applications that interface with the AG ISDN protocol stack at the CT Access level.

AG ISDN Messaging API Developer's Reference Manual

 Information on building applications that interface with the ISDN protocol stack via the AG ISDN Messaging API.

AG ISDN Supplementary Services Developer's Reference Manual

 A description of ISDN supplementary services accessible with AG ISDN software.

Hardware
This manual...

 Provides...

AG-T1 and AG-E1 Installation and Developer's Manual

 Installation procedures for an AG-T1 or AG-E1 board, and how to configure it for use. Also introduces T1 and E1 transmissions and signaling.

AG Quad Installation and Developer's Manual

 Instructions for installing an AG Quad board, and how to configure it for use. Also introduces T1 and E1 transmissions and signaling.

AG 4000 Installation and Developer's Manual

 Instructions for installing and AG 4000 board, and how to configure it for use. Also introduces T1 and E1 transmissions and signaling.

CT Access
This manual...

 Provides...

CT Access Developer's Reference Manual

 An overview of CT Access and a reference of functions, events, reason codes, and errors.

CT Access Installation Manual

 A description of the installation of the software from the distribution media and the configuration file. It also provides a procedure for verifying your installation.

Natural Access installation booklet

 An overview of the Natural Access CD-ROM, and instructions on installing software from the CD-ROM.

AG Runtime Configuration and Developer's Manual

 Information about the AG configuration file, agmon, AG board and driver error messages, and AG task processors.

The following manuals document the capabilities and functions of the AG ISDN-compatible CT Access services:


(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights reserved.