AG-24/30/48/60 Installation and Developer's Manual
P/N 6399-12
(Page 1 of 1 in this chapter)
About This Manual
Developer Support
1 About the AG-24/30/48/60 Boards
- 1.1 Introduction
- 1.2 About the AG-24/30/48/60 Boards
- 1.3 Software Components
- 1.3.1 About CT Access
- 1.3.2 About Runtime Software
- 1.3.3 About the AG Configuration File
- 1.3.4 About Trunk Control Programs (TCPs)
- 1.4 Installation Summary
2 Installing the Hardware
- 2.1 Introduction
- 2.2 System Requirements
- 2.3 Before Installing the Hardware
- 2.3.1 Configuring the I/O Address
- 2.3.2 Interrupt Conflicts in Mixed ISA and PCI Systems
- 2.3.3 Arranging AG Boards
- 2.4 Installing the Hardware
3 The AG Configuration File
- 3.1 Introduction
- 3.2 About AG Configuration File Structure
- 3.3 Creating an AG Configuration File
- 3.3.1 DSP Files and TCPs
- 3.4 AG Configuration Statement Summary
- 3.5 Assigning AG Board Numbers
- 3.6 Configuring AG Board Functionality
- 3.7 Configuring MVIP Bus Connectivity
- 3.7.1 Using MVIP Switch Models
- 3.7.2 Nailing Up DSP Resources
- 3.7.3 Restrictions for AG-48/60 Boards
- 3.7.4 Using MVIP-90 and MVIP-95 in One Application
- 3.8 About agmon
- 3.9 Sample AG Configuration Files
- 3.9.1 Two AG-24 Boards
- 3.9.2 AG-8 and AG-24, With MVIP Connectivity
- 3.9.3 AG-E1 and AG-60, With MVIP Connectivity
4 Verifying the Installation
- 4.1 Introduction
- 4.2 Verifying That Your Board is Installed Correctly
- 4.2.1 About agmon
- 4.2.2 Running agmon
- 4.3 Verifying That Your Board is Working Correctly
- 4.3.1 Using swish
- 4.3.2 Retrieving the AG Board Configuration: boardinf
- 4.3.3 Interactive Test Program: ctatest
Appendix A Glossary
Appendix B Hardware Specifications
- Introduction
- General
- PC-AT Interface
- MVIP Bus Connector
- Regulatory Certification (USA and Canada)
- Environment
- Power Requirements
- Indicators
- Host Interface
(Page 1 of 1 in this chapter)
tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights
reserved.