AG-24/30/48/60 Installation and Developer's Manual

P/N 6399-13
Version

(Page 1 of 1 in this chapter)

Table of Contents

About This Manual

Developer Support

1 Introduction

1.1 Introduction
1.2 AG-24/30/48/60 Boards
1.3 Software Components
1.3.1 CT Access
1.3.2 Runtime Software
1.3.3 AG Configuration File
1.3.4 Trunk Control Programs (TCPs)
1.4 Installation Summary

2 Installing the Hardware

2.1 Introduction
2.2 System Requirements
2.3 Before Installing the Hardware
2.3.1 Configuring the I/O Address
2.3.2 Interrupt Conflicts in Mixed ISA and PCI Systems
2.3.3 Arranging AG Boards
2.4 Installing the Hardware

3 AG Configuration File

3.1 Introduction
3.2 AG Configuration File Structure
3.3 Creating an AG Configuration File
3.3.1 DSP Files and TCPs
3.4 AG Configuration Statement Summary
3.5 Assigning AG Board Numbers
3.6 Configuring AG Board Functionality
3.7 Configuring MVIP Bus Connectivity
3.7.1 Using MVIP Switch Models
3.7.2 Nailing Up DSP Resources
3.7.3 Restrictions for AG-48/60 Boards
3.7.4 Using MVIP-90 and MVIP-95 in One Application
3.8 agmon
3.9 Sample AG Configuration Files
3.9.1 Two AG-24 Boards
3.9.2 AG-8 and AG-24, With MVIP Connectivity
3.9.3 AG-E1 and AG-60, With MVIP Connectivity

4 Verifying the Installation

4.1 Introduction
4.2 Verifying That Your Board is Installed Correctly
4.2.1 agmon
4.2.2 Running agmon
4.3 Verifying That Your Board is Working Correctly
4.3.1 Using swish
4.3.2 Retrieving the AG Board Configuration: boardinf
4.3.3 Interactive Test Program: ctatest

Appendix A Glossary

Appendix B Hardware Specifications

Introduction
General
PC-AT Interface
MVIP Bus Connector
Regulatory Certification (USA and Canada)
Environment
Power Requirements
Indicators
Host Interface

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights reserved.