(Page 2 of 6 in this chapter)

10.1 Introduction

This chapter presents the following demonstration programs and utilities shipped with the CT Access Switching service: Program/Utility Description drpinsrt Drop and insert with signaling monitoring. drpinsrt is not available in the SCO UNIX version of CT Access. prt2prt Demonstrates call transfer from an incoming line to an outgoing line and uses the Switching service to make connections, send patterns, etc. swish Allows interactive or text-file-driven control of MVIP switches. It provides a convenient way to manually try out connections during development to verify the commands that will be given to switches from within CT Access applications that use the Switching service. showcx95 Displays switch connections for all boards that have MVIP switches.
CT Access is shipped with source code for all demonstration programs. Each demonstration program is shipped as an executable program and with its source and makefiles.
Before you start the demonstration programs, ensure that: CT Access is properly installed. The AG board is executing. MVIP switching is correctly configured.
Refer to the appropriate installation manual for details on installation.

Program/Utility	Description
`drpinsrt`	Drop and insert with signaling monitoring. `drpinsrt` is not available in the SCO UNIX version of CT Access.
`prt2prt`	Demonstrates call transfer from an incoming line to an outgoing line and uses the Switching service to make connections, send patterns, etc.
`swish`	Allows interactive or text-file-driven control of MVIP switches. It provides a convenient way to manually try out connections during development to verify the commands that will be given to switches from within CT Access applications that use the Switching service.
`showcx95`	Displays switch connections for all boards that have MVIP switches.

(Page 2 of 6 in this chapter)