(Page 6 of 6 in this chapter)
10.5 Show Switch Connections: showcx95
Name
- showcx95
Purpose
- Displays switch connections.
Usage
showcx95 [driver]
Description
- Displays the switch connections for all boards that have MVIP switches. If a pattern is being sent on a timeslot, the pattern value is displayed.
Procedure
- To run showcx95 for AG boards, enter the following:
showcx95 agsw
Example
- If you have an AG board configured as board 0 with trunk channel 1 connected to local DSP resources (both voice and signaling) and you run these commands in swish:
SWISH: openswitch ag = agsw 0
SWISH: resetswitch ag
SWISH: makeconnection ag local:0:4..7 to local:5:0..3
SWISH: makeconnection ag mvip:0:0 to local:1:0 duplex
- The output will display as:
SHOWCX95 Version 1.1 Jan 15 1998
AGSW 0
M{00/01}:00 <-> L{00/01}:00
L-01:02 <- 0x7f
L-01:04..07 <- 0x7f
L-03:00 <- 0x00
L-03:02 <- 0x00
L-03:04..07 <- 0x00
L-05:00..03 <- L-00:00..04
L-05:04..07 <- 0x7f
L-07:00..07 <- 0x00
- In this output example,
M means MVIP bus and L means Local bus.
- This output example shows these types of connections:
L-01:02 <- 0x7f
- Pattern 0x7f is sent to timeslot Local:01:02.
- Timeslots Local:00:00..04 are writing to timeslots Local:05:00..03.
- Timeslot MVIP:00:00 is writing to timeslot Local:01:00.
Timeslot Local:00:00 is writing to timeslot MVIP:01:00 (a duplex connection).
(Page 6 of 6 in this chapter)
tech_support@nmss.com
Copyright © 1997, Natural MicroSystems, Inc. All rights
reserved.