(Page 1 of 1 in this chapter)

Chapter 7

Demonstration Program

NMS TAPI includes the intapi demonstration program for verifying installation and demonstrating the software's capabilities. The following section describes how to use the program.

Demonstrates the following TAPI-based inbound call-control functionality: Call answer/release. Asynchronous programming model for one line interface in one process. Play and record using callbacks.

intapi requires the following hardware and software: An installed NMS board. NMS TAPI software. A telephone handset connected to the board either through a PBX or CO simulator, or plugged directly into a DID hybrid on an NMS board.

intapi [options]
where options are: Option Description -l l Specifies the line number of the TAPI line to use. Default = 0. -? Displays instructions for using the intapi.

Option	Description
`-l` l	Specifies the line number of the TAPI line to use. Default = 0.
-?	Displays instructions for using the `intapi`.

To run intapi: Open a command window and navigate to the directory where intapi.exe resides (typically in c:\nms\nmstapi\demos\intapi). Enter the following: intapi No options are required, unless you want to change the TAPI line that intapi uses. Pick up the phone and dial into the PC on the TAPI line you specified. Select the record voice option. You hear the record beep prompt. Begin speaking after the prompt. The record operation terminates after you stop speaking and you are returned to the options menu. Select the playback option. The sample you just recorded will be played back. You are returned to the options menu. Select the hang-up option. You hear "good-bye" and the call is disconnected.

(Page 1 of 1 in this chapter)