NMS TAPI Installation and Developer's Manual

P/N 6438-12

(Page 1 of 1 in this chapter)

About This Manual

Developer Support

1 Introduction

1.1 Introduction
1.2 Telephony Application Programming Interface (TAPI)
1.3 Waveform Audio API (WAVE)
1.4 NaturalFax for TAPI
1.5 System Requirements

2 Installing and Configuring the Software

2.1 Introduction
2.2 Installing the Software
2.2.1 Upgrading NMS TAPI
2.3 Configuring the NMS TSP
2.3.1 Configuring TSP Settings
2.3.2 Configuring NMS Hardware
2.3.3 Configuring TAPI Lines
2.3.4 Configuring Telephony Parameters
2.3.5 Creating Custom Configurations
2.3.6 Testing the Configuration
2.4 Verifying the Installation
2.5 Enabling and Disabling NMS TAPI Components
2.5.1 Enabling and Disabling the NMS TSP
2.5.2 Enabling and Disabling the NMS WAVE Driver

3 Using TAPI Functions

3.1 TAPI Functions
3.1.1 Supported TAPI Functions
3.1.2 Using TAPI Functions With NMS TAPI
3.1.3 Supported TAPI Messages
3.2 Media Modes
3.3 TAPI Call States
3.3.1 Inbound Call States
3.3.2 Outgoing Call States

4 Using WAVE Functions

4.1 Supported WAVE Functions
4.2 Supported WAVE Audio Formats
4.3 Determining Supported WAVE Formats
4.3.1 Using waveInGetDevCaps and waveOutGetDevCaps
4.3.2 Using waveInOpen and waveOutOpen
4.4 The Audio Compression Manager
4.5 WAVE Device IDs
4.5.1 Managing I/O Buffers

5 Using NaturalFax for TAPI Functions

5.1 Introduction

6 Using Hardware-Specific Functions

6.1 Introduction
6.2 Using lineDevSpecific
6.2.1 Setting Parameters
6.3 Using lineSetMediaControl

7 Demonstration Program

7.1 intapi

Appendix A Glossary

Appendix B Removing the Software

Removing the Software

Appendix C Troubleshooting

Introduction
Installation
TAPI Functions
WAVE Functions

Appendix D NMS Board Parameters

Introduction
Function Parameters
Trunk Control Program Parameters

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights reserved.