(Page 22 of 46 in this chapter)

EnableMVIP

Syntax

EnableMVIP = YES | NO

Description

Specifies whether the current board(s) should be electrically connected to the MVIP-90 bus, H.100, or H.110 bus.
If EnableMVIP = NO: ClockRef cannot be MVIP or Sec8k. Switching commands connecting to or from the telephony bus will fail. agmon automatically issues switching commands to connect the analog telephone line interfaces (AG-8, AG 2000) or digital timeslots (AG-T1, AG-E1, AG Quad, AG 4000, CompactPCI AG Quad) to the on-board DSP resources.
If EnableMVIP = YES: Idle patterns are initially sent to line interfaces. All connections to line interfaces and DSP resources must be made by the application(s). If running ISDN, this includes connecting the HDLC controller to the appropriate line interface channel (for more information, refer to the AG ISDN For Natural Call Control Developer's Manual).
The EnableMVIP default values for the AG-T1, AG-E1, AG Quad, AG 4000, AG 2000, CompactPCI AG Quad, and AG-8 depend on the values of the ClockRef, DriveSec8K, and MVIPslot statements. If ClockRef = MVIP or SEC8K, DriveSec8K = NETx, or if MVIPslot is specified, then EnableMVIP = YES. Otherwise, EnableMVIP = NO.
The default, and only valid value, for AG-24/30/48/60 boards is YES.

Example

EnableMVIP = YES

See Also

ClockRef, DriveSec8K, MVIPslot

(Page 22 of 46 in this chapter)

tech_support@nmss.com

Copyright © 1999, Natural MicroSystems, Inc. All rights reserved.