(Page 15 of 46 in this chapter) Version
D_channel
Syntax
D_channel= YES|NO
Description
- This statement is used to set up NFAS groups and specifies whether a trunk carries the D channel for an NFAS group. For each NFAS group you specify in your AG configuration file, set
D_channel=YES for one (and only one) of the trunks in the group. Include the statement in the Trunk section describing the trunk.
- If you set
D_channel to YES for a trunk, set DigitalMode to PRI. If a trunk is part of an NFAS group but does not carry a D channel, specify DigitalMode=RAW for that trunk.
- The
D_channel statement is required in any configuration where NFAS is used. For more information about NFAS groups, see the AG ISDN Installation Manual.
Example
D_channel= YES
See Also
NFAS_Group
(Page 15 of 46 in this chapter) Version
tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights
reserved.