(Page 22 of 46 in this chapter) Version

EnableMVIP

Syntax

EnableMVIP = YES | NO

Description

Specifies whether the current board(s) should be electrically connected to the MVIP-90 bus, H.100, or H.110 bus.
The following settings are valid for EnableMVIP: Setting Description EnableMVIP = NO The following conditions take effect: · Default connections are established to connect voice and signaling information to DSP resources on the AG board depending on the value specified with the DigitalMode statement (CAS, PRI, or RAW). A different set of default connections is set up for each mode. For more information about the default connections created for each board in CAS, PRI, or RAW mode, refer to the board's installation and developer's manual. · Switching commands connecting to or from the MVIP90, H.100, or H.110 bus will fail. EnableMVIP = YES Idle patterns are initially sent to line interfaces. Because no default connections are made, all connections to line interfaces and DSP resources must be made by the application(s). If running ISDN, this includes connecting the HDLC controller to the appropriate line interface channel (for more information, refer to the AG ISDN For Natural Call Control Developer's Manual). Note: The ClockRef statement setting should not be set to the following when EnableMVIP = NO: MVIP Sec8K H100
Set EnableMVIP to YES in any of the following circumstances: If the ClockRef statement is set to MVIP, SEC8K or H100 If the DriveSec8K statement is set to NETx If the MVIPslot or MVIP95slot statement is used to specify a timeslot or range of MVIP timeslots driven by a board's DSP resources. (Because one of these statements is always present in AG-24/30/48/60 board configuration files, EnableMVIP must be set to YES for these boards.)

Setting	Description
`EnableMVIP = NO`	The following conditions take effect: · Default connections are established to connect voice and signaling information to DSP resources on the AG board depending on the value specified with the `DigitalMode` statement (`CAS`, `PRI`, or `RAW)`. A different set of default connections is set up for each mode. For more information about the default connections created for each board in CAS, PRI, or RAW mode, refer to the board's installation and developer's manual. · Switching commands connecting to or from the MVIP90, H.100, or H.110 bus will fail.
`EnableMVIP` = `YES`	Idle patterns are initially sent to line interfaces. Because no default connections are made, all connections to line interfaces and DSP resources must be made by the application(s). If running ISDN, this includes connecting the HDLC controller to the appropriate line interface channel (for more information, refer to the AG ISDN For Natural Call Control Developer's Manual).

Example

EnableMVIP = YES

EnableMVIP

Syntax

Description

Example

See Also