(Page 45 of 46 in this chapter) Version
TCP
Syntax
TCP = filename
Description
- Specifies the trunk control program for the current board(s). A trunk control programs perform all signaling tasks necessary to interface with the telephony protocol used on the line or trunk. TCPs are loaded onto an NMS board during initialization. After the TCP is loaded, applications must start the protocol before they can use the TCP to perform call control on specific ports.
- For more information about starting protocols on NMS boards, refer to the ADI Service Developer's Manual. For more information about loading and running TCP files, refer to the AG CAS for Natural Call Control Installation and Developer's Manual or to the AG ISDN for Natural Call Control Developer's Manual.
- The nocc.tcp trunk control program is installed with Natural Access. This protocol when no call control is being performed and it is not board specific.
Note: The TCP statement is required for configurations that run CAS signaling protocols.
Alias
TrunkControlProgram
Example
- Windows NT:
TCP =c:\nms\ag\load\did0.tcp
TrunkControlProgram =did0.tcp
- UnixWare and Solaris:
TCP =/opt/nms/ag/load/did0.tcp
TrunkControlProgram =did0.tcp
See Also
AG2DSPFile
(Page 45 of 46 in this chapter) Version
tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights
reserved.