(Page 4 of 9 in this chapter) Version
MTP3Flow
Description
- Applies (or halts) flow control to the specified service access point.
Prototype
- int MTP3Flow (U8 board, S16 sapId, S16 action)
- board TX board number.
- sapId Service Access Point ID.
- action Flow control action to take.
Return Values
Details
- To disable flow control, specify zero in the action field. A non-zero value will enable flow control. If flow control is active, incoming data messages will be buffered in the MTP 3 process until flow control is deactivated.
- When specifying a value for sapId, the same value used for the MTP3Bind request should be specified here as well.
See Also
- MTP3Bind
(Page 4 of 9 in this chapter) Version
tech_support@nmss.com
Copyright © 2000, Natural MicroSystems, Inc. All rights
reserved.