(Page 3 of 7 in this chapter) Version
MTP3Flow
Description
- Applies (or halts) flow control to the specified service access point.
Prototype
- DWORD NMSAPI MTP3Flow (CTAHD ctahd, S16 sapId, S16 action)
- ctahd Natural Access Handle.
- sapId Service Access Point ID.
- action Flow control action to take.
Return Values
Details
- To disable flow control, specify zero in the action field. A non-zero value will enable flow control. If flow control is active, incoming data messages will be buffered in the MTP 3 process until flow control is deactivated.
- When specifying a value for sapId, the same value used for the ctaOpenServices request should be specified here as well.
(Page 3 of 7 in this chapter) Version
Want to send us feedback on our documentation? Email: Tech_Pubs@nmss.com
Copyright © 2002, NMS Communications Corporation. All rights
reserved.