(Page 26 of 30 in this chapter)

SccpSetGenCfg

Description

Sends the SCCP general configuration parameters to the TX Series board.

Prototype

SCCP_STATUS SccpSetGenCfg (U8 board, SccpGenCfg *pCfg )
board The TX Series board number to which this request is directed.
pCfg The address of general configuration parameters buffer (format specified in the SccpInitGenCfg primitive reference).

Return Values

SCCP_SUCCESS
SCCP_BOARDThe board number is out of range.
SCCP_DRIVERAn error occurred accessing the driver.
SCCP_MAXROUTESThe value specified for pCfg->maxRtes is out of range.
SCCP_NULLPTRA null pointer was specified for pCfg.
SCCP_PARAMAn invalid parameter was detected. Check the txalarm log.
SCCP_RESOURCESA TX Series board resource is exhausted. Check the txalarm log.
SCCP_TIMEOUTThe request timed out.
SCCP_TIMERVALUEAn enabled timer has a value of zero.
SCCP_UNINITApplication failed to call SccpMgmtInit prior to this call.

Details

The first time SccpSetGenCfg is called after a download of the TX Series board, all the parameters listed in SccpInitGenCfg may be modified. On any subsequent call to SccpSetGenCfg (without downloading the board), only some parameters may be modified. These are listed in bold in the SccpInitGenCfg section. Those fields not in bold are ignored on subsequent calls.
SccpSetGenCfg must be called before any SCCP User SAPs, NSAPs, global titles or routes are configured.
The pCfg buffer must have been previously initialized with the SccpInitGenCfg primitive.

(Page 26 of 30 in this chapter)

tech_support@nmss.com

Copyright © 1999, Natural MicroSystems, Inc. All rights reserved.