TX 3220 Installation Manual
P/N 6504-13
Version
(Page 1 of 1 in this chapter)
Table of Contents
About This Manual
Developer Support
1 About the TX 3220
- 1.1 About the TX 3220 Board
- 1.1.1 Interoperability with MVIP-90
2 Installing the TX 3220 Board
- 2.1 Installation Summary
- 2.2 System Requirements
- 2.3 Configuring the Hardware
- 2.3.1 Terminating the H.100 Bus
- 2.3.2 Configuring the DIP Switches
- 2.4 Installing the Hardware
- 2.4.1 Installing the Board in Your System
- 2.4.2 Connecting to the MVIP-90 Bus
3 Configuring the Software
- 3.1 Introduction
- 3.1.1 Configuring the Software Under Windows NT
- 3.1.2 Configuring the Software Under Solaris x86
4 Updating the Firmware
- 4.1 Updating Board Firmware
- 4.1.1 Windows NT
- 4.1.2 Solaris x86
5 Verifying the Installation
- 5.1 Introduction
- 5.2 Status Indicator LEDs
- 5.3 TX 3220 Board Status LEDs
- 5.4 Verifying the TX 3220 is Installed Correctly
- 5.4.1 Viewing the Statistics for the TX 3220 Board (Windows NT)
- 5.4.2 Viewing the Statistics for the TX 3220 Board (Solaris x86)
6 Daughterboards and Cabling
- 6.1 Dual T1/Dual E1 Daughterboards
- 6.2 10/100Base-T Ethernet Daughterboard
- 6.2.1 Connecting the TX 3220 Boards for Redundancy
Appendix A Glossary
Appendix B Hardware Specifications
(Page 1 of 1 in this chapter)
tech_support@nmss.com
Copyright © 1999, Natural MicroSystems, Inc. All rights
reserved.