TX 3220 Installation Manual

P/N 6504-16
Version

(Page 1 of 1 in this chapter)

Table of Contents

1 About the TX 3220

1.1 About the TX 3220 Board
1.1.1 Interoperability with MVIP-90

2 Installing the TX 3220 Board

2.1 Installation Summary
2.2 System Requirements
2.3 Configuring the Hardware
2.3.1 Terminating the H.100 Bus
2.3.2 Configuring the DIP Switches
2.4 Installing the Hardware
2.4.1 Installing the Board in Your System
2.4.2 Connecting to the MVIP-90 Bus

3 Configuring the Software

3.1 Introduction
3.2 Configuring the Software Under Windows NT
3.3 Configuring the Software Under Solaris (Intel and SPARC)
3.3.1 Adding a Board
3.3.2 Configuring a Board
3.3.3 Deleting a Board

4 Updating the Firmware

4.1 Updating Board Firmware
4.1.1 Windows NT
4.1.2 Solaris (Intel and SPARC)

5 Verifying the Installation

5.1 Introduction
5.2 Status Indicator LEDs
5.3 TX 3220 Board Status LEDs
5.4 Verifying the TX 3220 is Installed Correctly
5.4.1 Viewing the Statistics for the TX 3220 Board (Windows NT)
5.4.2 Viewing the Statistics for the TX 3220 Board (Solaris)

6 Daughterboards and Cabling

6.1 Dual T1/Dual E1 Daughterboards
6.2 10Base-T Ethernet Daughterboard
6.2.1 Connecting the TX 3220 Boards for Redundancy
6.3 Quad V.35 Daughterboard
6.3.1 Frame Ground
6.3.2 Transmit and Receive Data
6.3.3 Request to Send/Clear to Send
6.3.4 Data Terminal Ready, Data Set Ready, and Carrier Detect
6.3.5 Ring Indicate
6.3.6 Clock Options Transmit Clock Pins 52

Receive Clock 53

External Clock Pins 54

Appendix A Hardware Specifications

General Features
Host Interface
H.100 Compliant Interface
Environment
Power Requirements
Compliance and Regulatory Certification

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 2000, Natural MicroSystems, Inc. All rights reserved.