TX 3220C Installation Manual

P/N 6544-17
Version

(Page 1 of 1 in this chapter)

Table of Contents

1 TX 3220C

1.1 Introduction
1.2 About the TX 3220C

2 Installing a TX 3220C Board

2.1 Installation Summary
2.2 System Requirements
2.3 Installing the Hardware
2.3.1 Installing the TX 3220C Board
2.3.2 Keying Information
2.4 Connecting to the T1 or E1 Trunk
2.5 Ethernet Connectivity
2.5.1 Connecting the TX 3220C Boards for SS7 Redundancy
2.6 Quad V.35
2.6.1 Frame Ground
2.6.2 Transmit and Receive Data
2.6.3 Request to Send/Clear to Send
2.6.4 Data Terminal Ready, Data Set Ready, and Carrier Detect
2.6.5 Ring Indicate
2.6.6 Clock Options Transmit Clock Pins 32

Receive Clock 33

External Clock Pins 34

3 Configuring the Software

3.1 Introduction
3.2 Configuring the Software Under Windows NT
3.3 Configuring the Software Under UNIX
3.3.1 Adding a Board
3.3.2 Configuring a Board
3.3.3 Deleting a Board

4 Updating the Firmware

4.1 Updating Board Firmware
4.1.1 Windows NT
4.1.2 UNIX

5 Verifying the Installation

5.1 Introduction
5.2 Network Status Indicator LEDs
5.3 TX 3220C Board Status LEDs
5.4 Verifying the TX 3220C is Installed Correctly
5.4.1 Viewing the Statistics for the TX 3220C Board (Windows NT)
5.4.2 Viewing the Statistics for the TX 3220C Board (UNIX)

Appendix A Hardware Specifications

General Features
Host Interface
H.110 Compliant Interface
Environment
Power Requirements
Compliance and Regulatory Certification

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights reserved.