TX 2000/TX 3000 Installation Manual

P/N 6701-12
Version

(Page 1 of 1 in this chapter)

Table of Contents

About This Manual

1 About the TX 2000/TX 3000

1.1 About the TX 2000/TX 3000 Boards
1.1.1 TX 2000
1.1.2 TX 3000

2 Installing the Hardware

2.1 System Requirements
2.2 Configuring the Hardware
2.2.1 Setting the Memory Address
2.2.2 Setting the Interrupt Request
2.3 TX 2000/TX 3000 Jumper Settings
2.3.1 Setting the Boot Options Jumpers (TX 2000 only)
2.3.2 Setting the Interrupt Type Options Jumper (TX 2000 only)
2.3.3 Setting the MVIP Bus Termination Option Jumper
2.4 Installing the Hardware
2.5 Installation Troubleshooting Information

3 Configuring the Software

3.1 Introduction
3.2 Configuring the Software Under Windows NT
3.2.1 Configuring the Software (SS7 2.0x or Earlier)
3.2.2 Configuring the Software (SS7 2.1x or Later)
3.3 Configuring the Software Under UnixWare 2.x
3.4 Configuring the Software Under Intel Solaris

4 Verifying the Installation

4.1 Introduction
4.2 Verifying the TX 2000/TX 3000 is Installed Correctly
4.2.1 Windows NT
4.2.2 UnixWare 2.x
4.2.3 Intel Solaris
4.3 Viewing the Statistics for the TX 2000/TX 3000 Boards
4.3.1 Windows NT
4.3.2 UnixWare 2.x
4.3.3 Intel Solaris
4.4 The tx2diag and tx3diag Utilities
4.5 The cpcon Utility

5 Pod Configuration

5.1 Changing the Pod Configuration
5.2 V.35 Pod Configuration
5.2.1 Frame Ground
5.2.2 Transmit and Receive Data
5.2.3 Request to Send/Clear to Send
5.2.4 Data Terminal Ready, Data Set Ready, and Carrier Detect
5.2.5 Ring Indicate
5.2.6 Clock Options

6 Adapter Cards and Cabling

6.1 10Base-T Ethernet
6.1.1 Connecting the TX 3000 Boards for Redundancy
6.2 T1/E1 Adapter
6.3 V.35 Daughterboard
6.4 Single Sub-360 Daughterboard
6.5 Triple Sub-360 Daughterboard

Appendix A Glossary

Appendix B Hardware Specifications

TX 2000 Specifications
TX 3000 Specifications

(Page 1 of 1 in this chapter)

tech_support@nmss.com
Copyright © 2000, Natural MicroSystems, Inc. All rights reserved.