(Page 35 of 41 in this chapter)
Version
boardCommand
Syntax
Integer
Access
Read-write
OID
p
.4.3.1.11.
n
, where
n
is the entry number.
Description
Setting the value of this object turns the board on or off. You can then check the
boardStatus
object to see when the command has completed. Valid values are:
Value
Action
1
On (same as closing the handles in physical Hot Swap).
2
Off (same as opening the handles in physical Hot Swap).
An operation must complete (not be in the pending state) before issuing a second command.
Note:
The value of this object only applies to CompactPCI boards.
Configuration
Not applicable.
(Page 35 of 41 in this chapter)
Version
Want to send us feedback on our documentation? Email:
Tech_Pubs@nmss.com
Copyright © 2000, Natural MicroSystems, Inc. All rights reserved.
(Page 35 of 41 in this chapter) Version (Page 35 of 41 in this chapter) Version