(Page 11 of 111 in this chapter) Version
Clocking.HBus.ClockSourceNetwork
Syntax
- Clocking.HBus.ClockSourceNetwork = networknum
Note: For more information about setting up CT bus clocking, and about the rules and restrictions that apply to setting up clocking with CG 6000C boards, refer to Section 3.5.
Access
- Read/Write
Type
- Integer
Default
- 1
Allowed Values
- 1 | 2 | 3 | 4 (1-based trunk number)
Example
- Clocking.HBus.ClockSourceNetwork = 1
Description
- Indicates the number of a trunk that the board uses as an external network timing reference for its internal clock.
- The board must have multiple external network connections and the Clocking.HBus.FallBackClockSource keyword must be set to NETWORK for this to take effect.
- When using Clocking.HBus.FallBackNetwork, the NetworkInterface.T1E1[x].Type keyword must be configured to either T1 or E1 and not to NONE.
Note: The Clocking.HBus.FallBackNetwork entry is a one based number, while the x entry in the NetworkInterface.T1E1[x].Type keyword is a zero based number
- If the Clocking.HBus.ClockSource keyword is not set to NETWORK, this keyword is ignored.
See Also
- Clocking.HBus.ClockSource
(Page 11 of 111 in this chapter) Version
Want to send us feedback on our documentation? Email: Tech_Pubs@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights
reserved.