(Page 87 of 111 in this chapter)
Version
NetworkInterface.T1E1[x].SignalingType
Syntax
NetworkInterface.T1E1[
x
].SignalingType =
type
x
=
0
..
3
(0-based trunk number or range of trunk numbers)
Access
Read/Write
Type
String
Default
CAS
Allowed Values
CAS | PRI | RAW
Example
NetworkInterface.T1E1[0..3].SignalingType = CAS
Description
Determines how voice and signaling information is routed to and from the E1 or T1 trunk and DSP resources. The switch model for the board changes based on the
NetworkInterface.T1E1[x].SignalingType
setting.
NetworkInterface.T1E1[x].SignalingType
can be set to any of the following values:
This value...
Makes settings appropriate for...
CAS
Channel associated signaling. This is the default value.
PRI
Primary-rate ISDN (31 bearer channels for E1, 24 bearer channels for T1).
RAW
Primary-rate ISDN with no signaling information (that is, not a D channel). Connects all channels as voice channels (B channels) and turns off robbed bit signaling (31 bearer channels for E1, 24 bearer channels for T1).
NetworkInterface.T1E1[x].SignalingType
is required for ISDN configurations. If no
NetworkInterface.T1E1[x].SignalingType
statement is provided in ISDN configurations, an
ISDN_BAD_NAI
error may be returned, even if the
NAI
statement is correct.
For more information, refer to
NetworkInterface.T1E1[x].D_Channel
.
See Also
NetworkInterface.T1E1[x].ConfigFile
,
NetworkInterface.T1E1[x].CRCMFMode
,
NetworkInterface.T1E1[x].D_Channel
,
NetworkInterface.T1E1[x].FrameType
,
NetworkInterface.T1E1[x].Impedance
,
NetworkInterface.T1E1[x].Length
,
NetworkInterface.T1E1[x].LineCode
,
NetworkInterface.T1E1[x].Type
(Page 87 of 111 in this chapter)
Version
Want to send us feedback on our documentation? Email:
Tech_Pubs@nmss.com
Copyright © 2001, Natural MicroSystems, Inc. All rights reserved.
(Page 87 of 111 in this chapter) Version (Page 87 of 111 in this chapter) Version